Seymour Duncan Pickup Hyperion Pickups for Bridge ・DC Resistance: Approximately 12kΩ (Measured with an analog tester, so there may be some error) ・Magnet: Alnico 5 ・Cable Length: Approximately 29cm This pickup was originally installed in an Ibanez AZ42P1-PBE. https://www.ibanez.com/jp/products/detail/az42p1_1p_01.html (Purchased new and used once in a studio, then removed by a professional guitar builder) The following is quoted from the website: 〈Quote〉 ●Seymour Duncan Hyperion Pickups We obtained dozens of pickups and measured the frequency characteristics of all of them. From these, we determined the specifications and sound image of the pickup that would be most suitable for the AZ series. This pickup was created in collaboration with Seymour Duncan, a pickup brand with a long history and a continuous pursuit of new developments. Designed with a focus on picking response and reproducibility, the output is kept relatively low to retain the original clean sound even when distorted. We prioritized the overall balance, from treble to bass, and from the 1st to 6th strings, and also pursued good effect compatibility. Alnico-5 magnets are used throughout. 〈End Quote〉 As shown in the photos, it is in almost new and clean condition. (However, there is some slight clouding around the pickup (this was present from the time of purchase)) Accessories include a Seymour Duncan storage case, unused mounting screws, and instructions (these were included when purchasing the SHPG-1b). ☀︎ I am also listing a "neck pickup" at this time. Please take a look as well. Thank you.