Leathercraft coin case pressing mold (black) This mold is for creating coin cases, but please feel free to use it for making small cases and other items as well. Pressing mold dimensions (convex part) Length: 65.0 mm Width: 60.0 mm Height: 11.0 mm Shape: Polygon Material: PLA resin The convex part has a 10-degree slope, making it easier to press. Please wet and soften vegetable-tanned leather before use. The image shows the mold used with 2.0mm leather. Here are the simple steps: Steps: ① Wet and soften the vegetable-tanned leather well (e.g., nubuck leather, up to 2.0mm thick). ② Place the leather on the male mold and lightly press with the female mold. → Then, place a wooden board or similar on top of the female mold, and secure it by pressing with a vise or hand press. ③ Remove after drying. Caution: When pressing, do not press the mold directly. Please place a board or similar on top to ensure even pressure. Tightening the mold itself with a vise may cause damage to the mold. #leathercraft #3dprinter #pressingmold #wetforming