Super Reactor Activation Copper Current Sensor Activation Extension Plate (Caution for use with Reactor products) Direct connection and use with items that discharge or release the energy of the reactor is not recommended, as it will diminish the reactor's effect. (Due to the completely opposite effects of discharge and supply, such as discharge cables and current sensor extension plates that have been discharged.) A good product has been made! Copper Current Sensor Activation Extension Plate. This is a copper extension plate for current sensors, compatible with current sensors. Furthermore, Super Reactor tape is also attached. It is a full set with a copper extension plate, a copper M6 bolt 12mm, and a nut and washer set. Set Contents * Copper 75mm extension plate with Super Reactor tape attached Hole size (M8, M6 combo) 1 piece, length 75mm, width 15mm (If you want both holes M8, please let us know in the transaction message. We will enlarge the holes.) * Copper Hexagon M6 bolt 12mm 1 piece * Copper washer 2 pieces * Copper M6 nut 1 piece Some scratches may occur on the surface during manufacturing and processing. Please understand. All made of copper. * The color of the copper of each part may vary slightly depending on the supplier. We have responded to the requests of those who want to connect the Super Reactor or grounding cable after passing the current sensor from the negative terminal of the battery. By replacing the bolts and nuts that secure the reactor with highly conductive copper, from the plate to the bolts, this is a plate and bolt set to allow the energy of the Super Reactor to spread throughout the entire vehicle body without waste from the negative terminal of the battery. This is for adding terminals for the Super Reactor and grounding cable terminals from the battery. For reference In the case of reactor connection, current sensor bypass bar? Avoid installing with inefficient materials with poor conductivity and unnecessarily expensive plates, as this will reduce the efficiency of the reactor! By using highly conductive copper products and connecting the reactor to the battery negative terminal, the energy transmission efficiency will increase. This is the most effective way to achieve results. Ice Extension IE-8 Current Control Sensor compatible bus bars, etc., also use copper materials that are strictly considered to not reduce efficiency.