Thank you for viewing! This is a jig for a front single-axis pivot sliding damper. It is made in a highly visible color to make cutting and marking easier when applied to carbon or FRP. *Colors are subject to change without notice. The roller width is 13mm, targeting 102.5mm. The slide range of motion is theoretically 5mm. Please adjust with spacers, etc. The product includes everything in the second image. The third image shows the carbon parts to be used. The fourth image shows the finished surface. The fifth image shows the finished back. The sixth image is an example of installation. By matching the cutting range, you can swap it with the separately sold 2-axis pivot slider or independent sliding damper. The carbon parts used are as follows: HG Carbon Rear Roller Stay (15mm) J-CUP2025 x 2 HG Carbon Rear Brake Stay (15mm) x 2 HG Carbon Front Wide Stay (15mm) x 2 HG 13/19mm Roller Carbon Multi-Reinforcement Plate x 1 set The parts using the straight plate and the pivot operating parts, etc. The slightly lower areas are unnecessary, so please cut them off at the end. These are unnecessary parts attached to the jig to make it easier to template and to fix the stay. You can assemble it as is if you don't cut off those parts. There are two ways to cut: either attach the jig to the stay, mark it, and cut, or attach the jig as is and cut. In either case, finish with a file at the end. A 100-yen store file is sufficient. The difference from the 2-axis is the range of motion. The 2-axis has more stability, but this one has more give. This one is also lighter and has a better recovery rate. However, the 2-axis has less wasted movement, so there is less resistance. So, if you prioritize speed, choose the 2-axis; if you prioritize recovery rate, choose this one. Please feel free to contact us if you have any questions. We also sell other jigs. Two for 1900 yen Three for 2800 yen, with a 100 yen discount for each additional one. Please request the above prices when purchasing together. Thank you.