DAWNFIELD PRODUCTS I've switched from a Jimny JB23 to a Jimny Nomad JC74. I've started developing original 3D-printed parts and items, utilizing my professional product design and engineering skills. ◎ Safety standard compliant design ◎ Uses 35mm screws, reinforced ball joint design This is a 3D-printed short stay for those who feel the original room mirror position of the Jimny Nomad JC74 is "a little low." It moves the mirror position approximately 32mm higher than the original, improving visibility. ■ Safety In the event of a collision, the design allows the stay to detach just like the original. It is a safety design that complies with safety standards. ■ Installation Use by replacing the original stay. When installing, replace the transparent parts attached to the original stay with this product, and then screw it to the vehicle body. ■ Required Tools ・ Interior panel remover (can be done by hand if you don't have one) ・ Phillips screwdriver (#2) ■ Product Specifications ・ Jimny Nomad JC74 exclusive design ・ Measured and designed by removing the original stay from a new car ・ Reinforced ball joint shaft (using 35mm screws) ・ Safety standard compliant design (original parts transplant/reuse design) ・ 3D printed (using ABS filament: heat resistant ◎ approx. 85℃) ・ Color: Gray (※ Black is also available upon request.) ■ Caution The inside of the car gets very hot in the summer. We do not recommend interior parts made of PLA filament because they may deform. This product is made of heat-resistant (heat resistance approx. 85℃) ABS resin. 【Product Management Number】 DFP-JN-ST-GR-V1-008 【Search Keywords】 #Jimny #JimnyNomad #JB74 #JimnyCustom #JimnyInteriorCustom #JimnyParts #RoomMirror #VisibilityImprovement #InteriorCustom #3DPrinter #3DPrintedParts #ABSResin #dawnfieldproducts