This is an original carbide triangular scraper from our workshop. The length before sharpening is 30mm. There are two types: the right one in photo 1 has a shaft diameter of φ2 (actual measurement approx. 2.4mm), and the left one is φ1.5 (actual measurement approx. 1.9mm). This is a single item listing. Please determine the thickness and angle from the title. Image 2 uses φ2. Please note that the approximate length is 30mm. Unlike the standard basic scraper with a house-shaped cross-section, this has a triangular prism cross-section with a 60-degree angle, making three edges, and is a cost-effective, low-priced scraper tip. The mirror finish provides excellent edge retention and sharpness. It's a versatile tool for chamfering and deburring plastics, modeling wax, urethane coatings, and even precious metals. Engraving scrapers are mainly used for polishing work, such as scraping off precious metals, but since it is a versatile tool, I made it for repairing the urethane coating on my fishing tackle. Made from the highest quality domestic carbide, and sharpened by me, it is, of course, a purely domestic product. Please be aware that Chinese products are not only poorly made but also have poor carbide materials. Notes: φ1.5 has a sharp taper to ensure the length of the blade, so it is not suitable for use on hard materials such as metal. Both φ2 and φ1.5 have a blade length of approximately 4mm (approximately 6mm at the top of photo 1, about 10°). There may be some individual differences in the diameter and color of the shaft. The length may be shortened to about 28mm due to sharpening. The tip is pointed, so φ1.5 in particular can easily chip if the tip is bumped. φ2 is close to the router shaft diameter, but it is not for use in a router or for scribing with the tip. Please use with caution, including wearing safety glasses, to avoid injury. This is a single item listing for the scraper tip (cap not included). The items in the photos are not included; they are for illustrative purposes. Please note that there may be slight differences from the actual product due to the use of images from other sources. Please use a pin vise or other method for the grip. φ2 is a bit thick for a 2mm core holder, but it may be usable depending on the object. We will handle initial defects, but we cannot replace items that are chipped or damaged after use. We can also adjust the angle during re-sharpening, which we can do separately after purchase. Delivery will be via Mercari's Nekopos service, including shipping. Workshop BijoDam http://bijodam.com/ Graduated from the Japan Jewelry Craft Engraving and Carving Department, CGL DC, Yutaka Ota