This is the internal circuit board for the HyperX Cloud Orbit S. It was removed from a used, good-condition unit during a balancing modification. It would be appreciated if you could use it for parts, etc. I confirmed that the basic functions worked before disassembly, but since it was removed by an amateur, it is considered junk. Please understand that it is sold as-is, and no claims will be accepted for any defects or malfunctions. The last two photos are for model number confirmation and assignment reference. The solder for the cable between the left and right sides has been removed. The headset body (exterior, drivers, etc.) is not included. It will be shipped via Yu-Packet Post (postal drop-off). It is also listed on other sites, so it may be canceled depending on the timing.