Thank you very much for checking the product! (*- -)(*_ _)Pecko This is a snap ring plier used for installing and removing snap rings. If you like, please purchase it immediately! Product Information ―――――――――――――― Set Contents Tips for installing and removing C-type clips for holes and shafts ・Straight tip: 2 ・Angled tip (45 degrees): 1 ・Angled tip (90 degrees): 1 ・Handle: 1 ・Tip fixing pin: 1 ・Size Approximately 15 cm x 9.2 cm x 2.5 cm Tool tip pin size: Approximately Φ1.45mm ・Material: High carbon steel, Polyvinyl chloride ・Handle color: Red C-type clips, snap rings, and circle clips are used to prevent the bearings from falling out of the rotating shaft or the inside of the hole. It is necessary when replacing bearings, and is used when fixing wheels, gears, and collars. It is a plier needed when installing and removing C-type clips during parts replacement or cleaning. When removing snap rings fitted in the grooves for shafts, Please use pliers that open at the tip when the pliers are gripped. When removing snap rings fitted in the grooves of holes, Please use pliers that narrow at the tip when the pliers are gripped. [About Shipping] Basically, we will ship within 1-3 days after payment is completed. [Notes] Depending on the size of the C-type clip, there are C-type clips larger than the maximum opening size. Please note that it cannot be used for large-sized clips. There is no outer box. We will ship in simple packaging. Thank you for checking the product description. If you wish, please purchase it as is!