This is an effects pedal stand made with a 3D printer. It's recommended for BOSS compact effects pedals, MXR, and other pedal effects. The 45° angle allows you to display your effects pedals. It has non-slip features, so you can turn the pedal switches on and off and adjust the knobs while they are on the stand. It also has one cable hole each on the back and bottom. You can pass cables from the power supply or shields through the back, and you won't have to worry about cable management or setup even when organizing wiring under the board like a slatted board. It will be useful when creating sounds at home or when you want to operate while maintaining visibility for recording purposes such as DTM. If you are looking for a practical stand, please consider it. 70mm x 135mm x 80mm (white) *Made with a 3D printer. There may be layer lines, support marks, and surface irregularities. Please purchase only if you understand this. *Effects pedals, cables, etc. in the photos are not included. *This is a set of 6.