Like new, purchased in December 2025. With box. The following is a quote: With the Xenagama Tail Loop MKIII, you won't waste space on your pedalboard. It takes up minimal space, with an incredibly compact depth of approximately 41mm. Because the switcher doesn't take up much space on the board, you can easily add it to your existing setup. Despite its small size, there's no compromise on functionality or operability. For example, it can consolidate the switching of effects pedals arranged in two rows on the board, and it can also supply power to three effects pedals and a pedal tuner. This switcher can handle the power supply, which can surprisingly take up a lot of space. All jacks are placed low to prevent cables from running over the effects pedals, and while minimizing the depth, the width is designed for ease of operation. Despite its space-saving design, the space between the footswitches is a generous 52mm, based on research from many players, reducing the risk of missteps. Furthermore, it achieves an exceptionally light weight for a switcher of this size. It weighs about the same as a typical compact effects pedal, making it easy to carry. Everything is designed for players who use effects pedals. Also, by connecting multiple effects pedals to a single loop, you can control all the effects pedals in the loop with a single footswitch. All the switches on the Xenagama Tail Loop MKIII are true bypass, so you can use vintage effects pedals, which can change the sound when bypassed, as true bypass. Equipped with a tuner out, you can completely isolate the tuner from the system. Power can be supplied not only to the pedals in the loop but also to the tuner. Also, even if a tuner is not connected, the TUNER switch on the right can be used as a mute switch, which is useful when switching between two guitars or when you absolutely don't want to make any sound during a song. Furthermore, a BJF Buffer is installed in the input section. It can be turned ON/OFF with a switch.