B-CLUB 1/100 Resin Kit Completed Build Overall Height (to the top of the head): Approximately 22 cm. Resin basic processes to painting. Metal parts for the vulcan, pins in several places on the shield, etc. Hand parts feel small, so they have been replaced with commercially available ones. (The kit includes a rifle and flat hands.) The propellant tanks had 3mm thick insertion pins, but they were prone to breaking, so they were cut off and remade with ABS material. The tail binders also had 3mm insertion pins, so these were replaced with aluminum pipes. These two points on the back are particularly prone to breaking, so they were changed. The movable kit has polycaps, but if you wiggle it around, the joints are resin and seem likely to snap, and it can't support the weight, so I think the straight standing pose of the example with the shield attached and the rifle held is best. (No hollow parts at all) The thickest joint is about 5mm, and the elbows are 3mm. When moving, do it slowly and gradually. At your own risk. This guy has a center of gravity towards the back and may fall over without support, so the ball joint in the crotch has been fixed. The thigh parts also caused the legs to fall off from the crotch due to the weight of the legs when lifting the body, so they have been fixed. This kit is a bit of a stretch! The legs can be spread left and right, and the ankles have been replaced with ball joints, so the grounding is sufficient. It has a terrifying number of parts, and it was a very difficult kit, such as incorporating polycaps. Personally, I think it's the coolest Gelgoog, but it's ranked in the top 20 of kits I never want to build again. The joints are resin! It was a bit of a problematic kit. Also listed elsewhere, so get it while you can. The images use a plate from another source, but it is definitely my listing. I will cancel the listing if it appears elsewhere. There are some imperfections in the surface treatment, but please make your judgment based on the current condition. Completed product, no claims, for those who want an MG size. (Note) The Cima figure and other items are used for the listing photos and are not included. Shipping will be done with the rifle (right wrist) and shield removed. Please attach them yourself. I think it would be difficult to reassemble the other parts if they were disassembled, so I will ship them as is, but if anything comes off or happens, please handle it yourself. *The figure is 1/7 and looks large, and the Gelgoog looks small, but it's a large MG size. Added images. MG Dom comparison. Cima-sama is quite large. Dom is not included. It doesn't come out like Gunpla. Price changed on 10/1 due to shipping cost increase. No further price reductions are possible. This is the lowest price now.