Please read the self-introduction section before purchasing (❁ᴗ͈ˬᴗ͈) This is a wooden hand press using a toggle clamp, which is convenient for leathercraft. You can clamp your tools with a drill chuck. Reduces noise when using a hammer. Makes work with chisels, punches, and stamps comfortable ♪ ※The product is the one with the wood grain pattern from the 15th image. (Color: Brown) ※The string hardware will be black as shown in the 19th image. ※When using, be sure to place the included board as shown in the 4th image and use it so that the hinge does not move. ※The last image is a reference sample image when using a die cutter. ★Product Set Contents Wooden hand press machine (with drill chuck) Striking tools and iron plate (as shown in the 1st image) Opening/closing stop plate ★Size ●Height: Approximately 35.5 cm ●Width: 30 cm ●Depth: 12 cm → when stored 22 cm (when in use) ●Usable tool diameter (drill chuck): From 2 mm to 13 cm, such as leathercraft hand tools ※Chisels and rivet setters are not included. ●Adjust the height by placing a cutting board or rubber plate according to the height of your tools or punches. ⚫︎When using a die cutter or punch, it is easier to make holes if you use an iron plate on the bottom. ★Precautions for use (images 19 and 20) The smooth molded plate surface of the seat will be scratched if you press the deformation die (③). ②The flat die is less likely to scratch the seat, but for large flat dies, it is easier to use if you make the seat larger. ※When using the press, if you are pressing something larger than the seat, or if the die has a design that deforms the seat, place an acrylic plate or iron plate in between (sandwich) and enlarge the seat. #Leathercraft #Chisel #Stamp #Punch #Die cutting #Genuine leather Tool...Punch Purpose...Leathercraft