※ Please be sure to read the notes at the bottom of this page before purchasing. This is a set of 4 parts and tools that can be used with the 3D printers Bambu Lab P1P/P1S. ・1 Bambu Lab-approved compatible hot end Mako for P1P/P1S ・2 corresponding nozzles to be used with the above 　・kaikaS1340 (0.4mm) 　・kaikaFIN1310 (0.1mm) ・1 torque wrench (2.0Nm) for attaching the nozzle to the hot end The 0.4mm nozzle has been used a few times (cleaned). The 0.1mm nozzle is unused. I tried one of the nozzles (0.4mm), and the print quality itself was good, but it didn't seem to suit my printing style, so I am selling it. 【Notes】 ・We cannot provide support regarding assembly or printing, so please consider purchasing only if you have the necessary knowledge. ・At the end of the product images, a card (photo) with the manufacturer's precautions that came with the product is included. Please be sure to check the contents in advance. This card will be included and sent with the product. ・Especially the 0.1mm nozzle is not a nozzle that can be used for printing just by attaching it. Since the printer and slicer software also do not assume this hole diameter, it is expected that considerable trial and error will be required to succeed in printing. Please understand this before purchasing. Usage reports are starting to appear on the internet, so please gather information. 3D printer Bambu Lab P1P Bambu Lab P1S Mako hot end KaikaFIN nozzle