Please be sure to read the profile section before purchasing. This product was handmade by Chikutaku (Kamechun). ◆ ★Please note that the amplifier in the image is not included in the listing. ★The production of the "Sponge Leg Amplifier Stand" will be the last of this product. This is because the position of the sponge legs on this product seems to vary, and the exact position is not always consistent. This is a wooden stand for the high-performance Chinese-made digital amplifier FX-AUDIO FX-98E. To use it, simply insert the sponge feet of the main unit into the foot holes, but the following steps are required: ① First, because the front panel of this amplifier protrudes slightly from the bottom, you need to apply four pieces of felt (brown in the image for visibility, but black will be used to make it less noticeable) near the feet to eliminate the difference in height. ② Next, you need to raise the foot holes so that the felt attached to the bottom does not touch the surface of the stand. Extra felt (the color may differ from the image) is included, so maintain this situation by layering it a little thicker, pressing it with your fingers, and finally, place the amplifier on top and carefully press it down to adjust the height and stabilize it. Once the above work is done properly, you will have completed the "Japanese-style Chinese amplifier" that "cushions the amplifier body with sponge feet and the felt underneath, and in case of emergency, the felt attached to the bottom of the body will cushion the impact, and the sponge feet will be inconspicuous." Show it off because no one else has one. (^.^) The material of the product is Ulin from Southeast Asia, known as a rot-resistant wood, heavier than water, famous as a wood deck. Approximate size: width 100 mm, depth 180 mm, height 29 mm, weight approximately 538 grams. Linseed oil is applied to the surface. Please be careful as it may transfer oil stains to anything it comes into contact with until it dries. ▲There are traces of the side dents being corrected. There are small cracks in the end grain, but they should not affect the strength. The work is also roughly made, so please do not purchase if you are concerned. Shipping will be anonymous shipping via Yu-Yu Mercari Mail Yu-Packet Post. 【Purpose of use, etc.】 Stand for Chinese-made amplifier Amplifier stand made of rot-resistant wood Ulin