Thank you for viewing. This is a jig for the AT Slide Pivot Bumper. The second image shows the product. This time, you can choose between 102.5mm (2) and 103.5mm (3), but please consider these as guidelines. The 3rd and 4th images are production samples. The carbon used is as follows: HG Carbon Front Wide Stay x 2 (glued) Rear Brake Stay x 2 HG Carbon Multi Wide Stay x 2 (glued) Straight Plate x 1 See image 5 The straight plate and the slightly lower part of the rear brake stay that receives the slide axis are unnecessary parts, so please cut them off at the end. These are unnecessary parts attached to the jig to make it easier to mold and fix the stay. You can assemble it as is if you don't cut those parts. There are two ways to cut: either attach the jig to the stay, mark it, and cut, or attach the jig as is and cut. See image 6 Finish both with a file at the end. A 100-yen store file is sufficient. See image 7 The slide body and the pivot arm parts, which have two pieces, need to be glued together with instant glue. Make sure to glue them firmly. For the moving parts, use either eyelets or flanged brass spacers as you like. I mainly shorten them and attach them to the main body. It can be used without them. The cutting position of the chassis is one straight plate's worth. See image 8. Depending on the chassis, it may be necessary to flatten the tapered part. Since it is compatible with the separately sold left and right independent slide dampers, you can easily replace them by simply swapping the units. See image 10 If you buy them together, you get a 100 yen discount. Please take a look at my other listings! Feel free to ask if you have any questions.