This is a set of battery relocation plates and holders for the TT02♪ Recently, it was sold to someone overseas! Thank you for your interest from overseas♪ The photo is olive green, but the item to be shipped is made of black carbon resin. It is a material with significantly higher strength compared to PLA, which is generally used in 3D printers^_^ Compatible battery size 96 x 48 x 20mm Designed to fit short LiPo batteries. Please check with your own battery size. (The overall length and height can be adjusted slightly with shims) If you fill the gaps with sponge, etc., according to your battery, the probability of damage will be reduced. Since there are many holes in the plate itself, Horizontal placement: 7 locations Vertical placement: 3 locations Position adjustment is possible (if there is no interference) Assembly requires: 7 pan head screws of about M3 x 6-8 2 countersunk tapping screws of about M3 x 38 (For high mount) 2 countersunk tapping screws of about M3 x 28 (For low mount) Pins to secure the lid These are not included, so please prepare them yourself. Features: It is designed to be compatible with the motor relocation kit I am selling, and the height does not interfere with the high mount (^^) Since the battery will be in a fairly high position, you will need to choose a body, but rear traction will definitely change dramatically♪ ※Since it is 3D printed, there may be problems with strength. In the unlikely event that it breaks immediately, there is basically no warranty, so please understand. However, I think it will be fine as it doesn't break even if you swing it around with the battery in it. It takes more time to manufacture because of the large number of parts, so the price will be higher than usual, but thank you to those who need it.