This is an original, fully painted work based on the 1/144 Gundam Beyond Global. After performing basic treatments [gate processing, seam removal in noticeable areas, sanding with 400-600 grit for paint adhesion], I fully painted it with an original design. As part of the modifications, I removed the cross design on the shield and the pegs that remain on the left and right sides, filled them with putty to create a smooth surface, and then applied original design decals I created myself using design software. I have varied the damage depending on the part and material. I personally paint with a concept in mind, but it is only complete when the buyer gives it their interpretation, so please feel free to create your own background for it. 〈Notes〉 ※ The stand used during photography is not included. ※ Top coating is done with a total of 5 layers of clear coat, adjusting the gloss level from glossy to matte. However, this is more of a wish than a guarantee, and as it is not an industrial product, but rather an amateur work based on a commercial product, please handle it with the utmost care. To check for clearance, I applied a primer surfacer once, and then performed an articulation check, cutting away any areas of interference between parts and leaving areas where the design changes significantly and are not visible unpainted to ensure clearance. ※ Painting of unseen areas such as the underside of the waist armor and the inside of the shoulder armor has been omitted for the above reasons. The inner side of the forearm, which is the only visible part, is also unpainted, but due to the cutting tolerance for the strength of the parts, painting it would still cause contact. Although it is in a position that can be seen if you try, please understand that it is unpainted. ※ When attaching the beam saber to the backpack, the paint on the tip of the handle will inevitably peel off due to the way it fits and holds. Therefore, I will include an extra saber handle with effect parts, etc., as a design. You can also remove the saber that is already attached, but please do so at your own risk. ※ For shipping, I will wrap the parts with protective sheets, sandwich them with corrugated urethane, and ship them in a completely immobile state. (In fact, I performed an impact test with my other painted works in this state, throwing a catchball relay, and they were undamaged.) Due to the irreplaceable nature of the product, please understand that no claims or returns are accepted to prevent substitution.