Thank you for viewing. [Notice] We are planning to revise prices soon. Please refer to my profile for details. This is an RCA input/output cable (0.3m) for the Cyber Navi 910-912 IV series. Sound quality improves simply by replacing it with the original cable. ☆ Not compatible with the multi-drive assist unit connector. If you use it, please transplant the original connector. For audio output, we use MOGAMI 2549, which is highly regarded as a recording studio microphone cable. I still vividly remember being surprised by the improvement in high and low frequency extension and resolution when I switched from the MOGAMI 2534, which is considered a standard in my system, to the 2549. For video, we use the flexible 75Ω coaxial cable MOGAMI 2964 with stranded conductors, and MOGAMI 3080 for microphone input. We also offer products where you can order cable length and subwoofer branching, as well as products for direct amplifier insertion, so please take a look. [Soldering] We use WBT-0800 silver solder and a temperature-controlled soldering iron, and insert it into RCA plugs with heat dissipation measures. [Shielding treatment] We ground the shield only on the RCA jack side, and avoid twisting the shield and conductor together, performing them separately to reduce the solder between the conductor and the jack. [Confirmation after production] We confirm that there are no wiring errors with a continuity check using a tester, and that there are no short circuits, and then complete the product. [Evaluation equipment] Main unit ・AVIC-CZ902XS Power amplifier ・PRS-D800 (2CH High) ・PRS-D800 (2CH Mid) ・PRS-D800 (Bridge SW) Speakers ・DS-G400 (Front 2-way active network) ・SW-G50 (Subwoofer) Stabilized power supply ・AT-RX80 (Main unit) ・AT-RX100 (High/Mid amplifier) ・AT-RX100 (SW amplifier) Thank you for your consideration.