Four Ginful PS5 TMR Sensor V2 120gf units. Compatible models: PS5-Edge, and all models of official controllers. *Includes low-melting-point solder, 3mm diameter, approximately 10cm long. #NoteP5Parts (See various PS5 peripheral parts.) Optimized from V1 due to switch specification changes. *Basic performance is almost the same. Consider it as a newer manufacturing date. Please understand that Hall effect sensors and TMR sensors are different. In terms of performance: Gulkit TMR → (performance is almost the same as Hallpi) Hallpi → Ginful, K-silver → and below are Hall effect sensors. Compared to Hall effect sensors, they offer higher precision, lower noise, and longer lifespan. 120gf refers to the stick's push-down strength. FPS users can benefit from stronger push-down to prevent accidental inputs. Typically, it's 100gf. *A separate listing includes regulators compatible with PS5 and PS4 (Edge requires a dedicated one). Installing this further improves stick accuracy; consider it if your budget allows. Because it's a digital system, the parts don't make contact, reducing drift caused by wear. Instructions for using the software adjustment tool are available on YouTube, and I will provide the link via transaction message after purchase. Junk Repair PS5 Controller DualSense Replacement Parts TMR Sensor Hall Effect Sensor