~Handmade~ Polymer Clay Cutter *Mini Camellia 12mm* Color: Random This polymer clay cutter is made using PLA filament. A 12mm mini size, perfect for stud earrings and attached parts.*˖⋆ 0.4mm edge for a clean cut, smooth processing after cutting and baking.*˖⋆ Rounded base that is gentle on fingers.*˖⋆ Size: Approximately at the largest part Design part 12mm Height 13mm Color: Random · · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · · PLA filament is a material developed based on plant-derived PLA resin - mainly made from natural materials such as corn, potatoes, and tapioca, it is a plant-derived biodegradable bioplastic. This product uses high-purity, high-strength PLA/PLA+ filament.*˖⋆ ☆3D printing builds up by layering melted filament - We create with settings that minimize layer lines as much as possible, but there may be some areas where there are shifts, burrs, layer lines, and stringing, so please understand. ☆When using, especially cutters with fine designs, apply cornstarch etc. to the cutter when cutting, or remove the clay by pressing and removing it in small increments, rather than all at once, to prevent sticking and make it easier to remove. ☆Due to the nature of the product, clay may enter the layers. Please wipe it off using a soft brush or cloth without applying force. ☆Although it is a strong and tough material, please be careful as excessive force, especially from the horizontal direction of the layers, may lead to damage. ☆PLA filament is generally weak to heat and softens even at low temperatures of around 60°C, so please be careful about the temperature when washing - Dishwashers cannot be used. #akikaClayCutter #polymerclay