~Handmade~ Polymer Clay Cutter *Osmanthus & Lilac 10mm* ☆Minor Change Version Color: Random This is a polymer clay cutter created using PLA/PLA+ filament. A set of Osmanthus and Lilac.*˖⋆ For creating delicate small flowers⋆.˚⊹⁺ By raising the petals, you can recreate the fluffy blooming appearance. Single structure type with an integrated cutter and wall.*˖⋆ The strength of the joints has been increased, improving usability and stability. 0.4mm edge for a clean cut, smooth processing after cutting and baking.*˖⋆ A base that is gentle on rounded fingers.*˖⋆ Size: Approximately at the largest part Design part 10mm Height 15mm Color: Random · · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · · PLA filament is a material developed based on plant-derived PLA resin. It is a plant-derived biodegradable bioplastic made mainly from natural materials such as corn, potatoes, and tapioca. This product uses high-purity, high-strength PLA/PLA+ filament.*˖⋆ ☆3D printing builds up by layering melted filament. We manufacture with settings that minimize the appearance of layer lines, but please understand that there may be areas where shifts, burrs, layer lines, and stringing occur. ☆When using, especially cutters with fine designs, apply cornstarch or similar to the cutter when cutting, or remove the clay by pressing and removing it a few times little by little instead of all at once, making it less likely to stick and easier to remove. ☆Due to the nature of the product, clay may enter the layers. Please wipe it off using a soft brush or cloth without applying force. ☆Although it is a strong and tough material, it may be damaged if excessive force is applied, especially from the horizontal direction of the layers. Please be careful. ☆PLA filament is generally sensitive to heat and softens even at low temperatures of around 60°C, so please be careful about the temperature when washing. Dishwashers cannot be used. #akikaClayCutter Cutting mold Resin clay Osmanthus