Pocket-sized holds. These plastic holds were made with a 3D printer. Although the depth is shallow, about 3 cm, they are incut by about 20 degrees, providing a good hold. They can be held with two or three fingers (narrow grip). Recommended for pocket beginners to intermediate climbers. Friction can be felt to some extent even without chalk. Sufficient friction can be felt by using chalk or PD9 in combination. ⚠️ Important Notes for Use Compared to general resin molded or urethane holds, the strength is inferior. The manufacturer himself uses them daily, and no major problems have occurred to date. Over-tightening the screws can cause damage. Please be careful not to overtighten when installing. PD9 is for size comparison and is not included. Please use at your own risk.