Compatible car manufacturers: Toyota, specifically for the new Sienta! Type of accessories: Both side & rear & front emblems Material: Acrylic resin, tomato red sienta Exclusively for the Toyota new Sienta, this includes side moldings, rear, and front emblems. These are custom-made products using laser processing. They are dress-up parts that attach to the recessed areas of the Sienta's side molding, where the "sienta" logo is located, using strong double-sided tape. There are many aftermarket products with Roman alphabet logos, but most are just cut-out sheets... These products use acrylic resin, so you won't have issues like air bubbles getting trapped underneath, unlike with cut-out sheets! Page 3 shows actual installation images. Note: The installation images show a different color than the one being sold! Installation method: Strong double-sided tape is pre-applied to the back of the Roman alphabet plates. Simply fit them into the logo area under the side molding of the car. It is important to thoroughly clean the installation area before attaching them! On my own car, I installed them in February 2023, and I haven't had any problems like them falling off or breaking! These are custom-made products, so please understand this before purchasing. There may be some blackening on the edges from the laser processing, and slight unevenness in the cut-out areas of the letters. Please refrain from purchasing if you are overly concerned about these details. I do not negotiate prices for custom-made products! m(__)m Also, I am not responsible for any damage to your car caused by the installation of these products. m(_ _)m