【※Plate not included.】 This is an assembly for a Jazz Bass. Recommended for those who want to upgrade their current bass! Assembly Introduction 【Pots】 Entry-level basses often have metric-sized holes in their plates. I considered CTS pots, which are famous for their quality, but CTS pots are inch-sized and not compatible. Therefore, I chose Alpha pots, which are metric-sized and of good quality. They are 250kΩ, a good match for basses. You can install them directly onto your existing plate. This time, I made them with full-size pots. 【Jack】 The jack is made in Japan. The quality is quite good, and I feel it's not much different from Switchcraft. 【Wiring】 The wiring uses cross-wire, which is also used in Fender and other high-end guitars. It's quite stiff and durable. ※Cross-wire will be either skin-colored or yellow. It's usually skin-colored, but sometimes it's yellow. Please understand that there is no change in functionality. 【Capacitor】 The capacitor is the classic good-quality Orange Drop. Specs → 200V 0.047uf It gives a clear sound even when the tone is adjusted, without sounding muddy. As described above, I have put a lot of care into the quality. All parts are new. All pots have noise reduction grounding, so there is very little noise. Please feel free to upgrade. Please refer to photos 3 and 4 for pickup wiring and pot dimensions. Power-on tested. Shipping will be via Yu-Yu Mercari Mail A4 size brown envelope. If you are worried about wire breakage, I can send it via Yu-Yu Mercari Mail Yu-Packet Plus for an additional 200 yen. I have already kept the price as low as possible, so I cannot offer any further discounts. #Bass