Replacement drive for Sharp AQUOS Blu-ray recorders. Made in 2014. Maintenance performed, including disassembly, cleaning of the pickup lens, and greasing of the opening/closing mechanism. Compatible with most models, but some may not be supported. If you open the top cover and see a drive of the same appearance installed, replacement is generally possible. Compatible with BDR-L06 and L07 series. *Cannot be used in BD drive-integrated TVs. ✦The BDR-L08SHB-XP is a high-performance drive that revamped the fragile AQUOS BD drives of the past. It excels at both reading and writing and can be used for a long time. When replacing a BD drive, it is recommended to replace it with the L08 series from 2013 onwards, rather than searching for the same model number that failed. (Many L07 series drives fail regardless of usage time, only based on the power-on time. Some opinions consider them defective.) ●See image 3 for power-on time and usage time. *May increase from the displayed values for operational checks. ●2-week operational warranty after receiving evaluation ●Compatible models BD-W**, T**, S**, H**, HW**, and others (where ** are numbers) from 2011 and later *Repairs are at your own risk. Support will be provided as much as possible, but please understand that claims due to your own operational errors are not accepted. ▼Replacement method ① Remove the two side screws and the three rear screws of the top cover. (Be careful not to remove the fan screws) ② Slide the top cover backward to remove it, then remove the four screws from the corners of the old drive and take out the drive. Disconnect the SATA plug on the drive side. ③ When installing the new drive, follow the above steps in reverse. *Depending on the model, it may be necessary to remove the front panel. ⚠ Be careful not to lose the screws. *No price reduction However, discounts are available for multiple items: 300 yen off for 2 items 810 yen off for 3 items #Tsukiboshi AQUOS Repair Parts