New FMW piton clamp receiver & base. This is a fitting used to secure the rod butt using a one-touch clamp. By slightly widening the clearance under the shaft, the one-touch clamp will not interfere with the main body even if the rod is raised to about 80 degrees, making it easy to handle. Basically, it can be used with a single anchor, but if the installation location is weak, such as sandstone, double anchoring provides stronger fixation. (When installing with only one hole, use the smaller hole) The base is threaded, allowing for slight height adjustment. Although the adjustment range is not large, you can raise and lower the rod tip to some extent just by slightly adjusting the rod butt side up and down. *Caution: Even when raising the height, always use it with at least 8 rotations screwed in. If the screwing is insufficient, there is a risk of detachment. *Piton clamp is not included. Manufacturer: FMW Material: Super duralumin Bolt holes support M10, 3/8 to M12. ■About the material Made of super duralumin, a lightweight, high-strength material also used in aircraft. The specific gravity is only 2.8g/cm3, less than half that of stainless steel (7.93g/cm3), and the tensile strength is about 570N/mm2 for super duralumin, compared to about 520N/mm2 for stainless steel, boasting high strength. Each item is produced by cutting from the material, so the cost is inevitably high, but the absence of welding points reduces the risk of breakage. → #Other FMW products are here [Rod clamp, rod keeper, ishidai, ara, kue fishing, bukkomi fishing, bottom fishing, piton, ishiduki BOX, rod rest]