I will ignore comments requesting discounts. This is mold-making silicone, silicone mold diluent, and thinning agent, 500g. Please note that the container may vary depending on the lot, such as a round or square polyethylene bottle. This product can be used to lower the viscosity of silicone rubber or make it softer. The standard addition amount is around 1-5% by weight. If you add more than 10%, the physical properties of the silicone rubber will deteriorate, and oil may seep out. Please be careful. The catalog is listed at the bottom of this product description. Please understand that the container may be deformed during transportation. The following are catalog values: Colorless and transparent. High flash point. Small viscosity change with temperature. High compressibility. Excellent heat resistance and low-temperature properties. Low surface tension. Excellent electrical insulation. Excellent water repellency, mold release, defoaming, and gloss. Physiologically inert. Low corrosiveness to plastics. 【Physical Properties】 Appearance: Colorless and transparent liquid Viscosity: mm2/s (25℃) Approximately 35 Viscosity Temperature Coefficient V.T.C.* 0.595 Specific Gravity: g/cm3 (25℃) 0.96 Coefficient of Thermal Expansion: cm3/(cm3・℃) x 10-4 (0-150℃) 9.25 Thermal Conductivity: W/(K・m) (50℃) 0.15 Flash Point: ℃ DIN 51755 >300 Pour Point: ℃ -50 Volatiles: % 230℃/2hr <2.5 Refractive Index (25℃) 1.402 Dielectric Constant (25℃, 102Hz) 2.73 Surface Tension: mN/m DIN 53914 21.1 (The data listed is not a shipping standard.) *V.T.C.: Abbreviation for Viscosity Temperature Coefficient This is an index that indicates the change in liquid viscosity with temperature; the smaller the value, the smaller the change. V.T.C. = Kinematic viscosity at 99℃ / Kinematic viscosity at 38℃ 【Storage Precautions】 Store in a sealed container in a cool, dark place. 【Hazardous Materials Classification by Fire Service Law】 Designated Flammable Materials This product has been developed and manufactured for general industrial use. If used for medical purposes or other special applications, please test it in advance at your company and confirm its safety for that application before use. In addition, do not use it for applications where it may be implanted or injected into the body, or where a part of it may remain in the body.