※ This product is only the tilt stand. ※ Anonymous delivery Made with a 3D printer. This is a tilt stand for the trackball mouse Logitech ERGO M575. (Also compatible with ERGO M575SP and M575S) The tilt angle is set to 20°. I made it to match the tilt angle of the Logitech MX ERGO as much as possible. I personally like the 20° tilt angle stand and actually use it attached. (However, since there are individual differences, 25° and 30° are also sold separately) Using the tilt stand allows you to fix your wrist at a more natural angle. This allows for operation with a relaxed arm posture, reducing the strain on your wrist. The color and texture are close to the original, without compromising the design of the trackball mouse itself. Five non-slip pads are attached to the back of the stand for stable use. You can operate the power switch with the stand attached. It is fixed in two places: the ball hole and the cover groove. The USB receiver and battery cover can be stored inside the stand. Color: Black Material: (Body) PLA, (Non-slip) High-performance urethane foam 《Notes》 ・The trackball mouse itself is not included. ・Please refrain from using it in a high-temperature environment. (Heat resistance: approx. 60℃) ・3D printed products may have fine horizontal and vertical stripes, and stringing. ・Color may adhere from the non-slip pads to the contact surface, such as plywood flooring and vinyl chloride flooring. ・Do not use the product for purposes other than its intended use. ・Do not perform actions that may cause damage or handle it roughly. ・Do not use damaged or deformed products as they are. ・We inspect the products before shipping, but please contact us if there are any defects. We will respond as much as possible. ≪Installation Method≫ 1. Store the USB receiver in the stand. 2. Store the battery cover. 3. Hook the fixing claws onto the cover groove of the mouse body, and then insert the fixing protrusions into the ball hole.