KH Racing New Discharge Unit - Controls 2 Sets Simultaneously This unit has both a race-specific discharge mode and a constant current normal discharge mode. It operates on two AA batteries or USB TYPE-C, and voltage management is more accurate than with self-powered units. The maximum discharge current is 3A. We believe this discharge unit is effective for setting the optimal voltage for races and courses. Instruction manual included. ■ Product Specifications ・Text color: White ・Operates on 2 AA batteries or USB power. (★Does not operate with the batteries being discharged) ・Controls the discharge of 2 sets of batteries completely independently. ・USB port: TYPE-C (Not PD compatible) ・Discharge voltage setting: 1.8V~3.2V, adjustable in 0.01V increments ・Throttle discharge function (discharge current: 0.5～3.0A, in 0.1A increments) ・Constant current discharge function (discharge current: 0.3～3.0A, in 0.1A increments) ・Voltage and discharge current values are backed up. ・Discharge capacity measurement and average discharge voltage measurement function. ■ Important Notes ・If there is a difference in the charge state (usage state) of the two batteries, over-discharge may occur. Discharge will stop when the total voltage of the two batteries falls below 1.75V. ・Use of AA batteries other than Neo Champ is at your own risk. ・Do not place metal objects near the circuit board. Short circuits between terminals can cause failure. ・The heat sink and resistors will become hot during discharge. Please be careful. ・Do not leave the unit unattended during discharge. ・This product is made by an individual. Please use with caution. We are not responsible for any fire, injury, etc. Use is entirely at your own risk. ■ Discharge Function Explanation ① Throttle Discharge (Race Mode) Set the target voltage and the maximum current value for discharge. After discharge starts, the current value is automatically adjusted by comparing the target voltage and the battery voltage. ② Constant Current Discharge (Normal Mode) Set the target voltage and the current value for discharge. Discharge will continue at the specified current value until the target voltage is reached. ③ Voltage Hold Mode Discharge will restart when the voltage rises a certain amount from the target voltage. This helps to suppress the voltage recovery.