Thank you for viewing! I'll start with my usual preamble, so if you don't need it, please skip to the product description below m(__)m A few days after I started selling the LP-86 axle position change kit, a colleague from my radio-controlled car club's company asked me, "I understand that changing the axle position is effective, but the Hikotech VIA knuckle actually shifts the axle, right? Which one is better in the end?" That got me thinking. I looked into it, and sure enough, they intentionally increased the trail amount? ( ..)φ Memo memo What's different from the LP-86 original is that the VIA knuckle has a kingpin angle of 0 degrees, and a caster angle of 0 degrees. I wonder how it moves? Will it really make it easier to drive?? Even to try it out, it's a lot of money (-_-) Too expensive for a low-wage salaryman...(´;ω;｀) And so, I couldn't sleep at night... So, I made it! ★Product Description ・By installing this kit, 　the LP-86 will have the same foot movement as if you installed a VIA knuckle (probably) ・Camber angles can be selected from 5, 7, and 9 degrees, with 3 sets included♪ ・A servo mount specifically designed for a caster angle of 0 degrees is also included♪ ・The trail amount is set to 3mm to match Hikotech (LP original is about 5mm?) ・By changing the trail amount, the arm position is moved back, and the wheelbase is roughly the same♪ ・The material is black carbon-filled resin. •F104 suspension ball is used for smoother movement than the original♪ ★Notes ・Of course, it's not as high-precision or high-rigidity as the original, it's just a 'like' product, so please understand (*^-^*) ・Since it's 3D printed, there may be burrs, stringing, and roughness on the support removal surfaces. Please adjust and correct it yourself. ・The original can change position front and back, but this one cannot move front and back due to shape simplification. It's a manly specification of 3mm only! ・There is no warranty if it breaks immediately, but I want to improve the product, so I would appreciate feedback (I will provide some service next time) ・The product is only the 3D printed product in the first photo. 　There are other necessary parts, so please refer to the photo m(__)m I've written a lot, but you should be able to experience the VIA knuckle-like movement relatively inexpensively, so please give it a try♪