Leen Castina Life-size Air-Filled POP Air Cushion ⭐️ This is a life-size inflatable vinyl product. The image on the second photo is an inflated image. The illustration on the first photo becomes three-dimensional like the second photo. You can stand your favorite character. It can also be used as a body pillow. Double-sided printing with two patterns on the front and back. ⭐️ The illustrations seem to be the same as those used for body pillows. Probably, but not certain (because it is an unopened product). It is a new, unopened product that has been stored. Selling a large number of items due to decluttering. You can get a discount if you buy in bulk. Body pillow covers, air-filled products, tapestries, anything is OK. I think you can also use it as a body pillow, so please consider it as a companion for your room. If you have no questions, you can purchase it as is. The following is an explanation. Height: Approximately 160cm Made of PVC, UV printing, water-filled bottom type By putting water in the bottom, it becomes a tumbler. 1. Inflate with air through the air inlet. Please inflate with air from the air inlet on the punching bottom. When it is about 70% inflated, stop once. If you inflate it too much here, it will be difficult to put water in the water inlet. 2. Fill with water from the water inlet at the bottom. You can pour water directly from a plastic bottle. In that case, open the lid and use a funnel to slowly pour in the water. 3. Finally, inflate with air again. Be careful not to over-inflate, as this may cause it to burst or leak air. Secret