Hurry, get it while it's cheap! ・ES CON FIELD HOKKAIDO Modeled in 3D CAD using publicly available architectural data and Google Earth photos. Created using an FDM 3D printer. This time, due to the print settings, too much support material was used, and it couldn't be removed, resulting in damage. It's a shame to throw it away, so I'm putting it up for sale. Please use it for a Gunpla diorama. Scale: Approximately 1/1700 Color: White Size: 142 x 188 x 46 Material: ABS The movable roof rail is damaged, as shown in the photos. About 7 support pillars are coming off, but I'll include repair support pillar parts, so it should improve significantly if you glue them properly. The rear roof and broadcasting facility parts are warped due to ABS shrinkage. I removed the parts above the first base entrance to allow a view of the concourse, but support material is attached to the entire concourse and won't come off. Forcing it off further will cause damage. Support material also won't come off on the third base side. The 2nd and 3rd floor seating is divided into parts, but they don't fit well. Tower 11 is also divided into parts. ・Sapporo Dome Modeled in 3D CAD using publicly available architectural data and Google Earth photos. Created using an FDM 3D printer. Scale: Approximately 1/1700 Color: White Size: 144 x 133 x 43 Material: ABS You can remove the roof to see the field. Attaching the soccer mode parts will put it in soccer mode. There is some remaining support material and some printing defects. The 1/1700 White Base, mobile suits, etc., shown in the photos are not included. #WhiteBase #Gunpla #Hokkaido Nippon-Ham Fighters