No discounts. Please read the self-introduction section. Over 10 years of sales! Tens of thousands of sets sold! Many repeat customers use these stays. This is the 10th year of improvements. The corners have been rounded to reduce the cheap look. The appearance has also become much smarter. New, 1 set. Universal product with stainless steel (SUS303) stays, and other parts are chromate plated (hex socket 4.0). Compared to similar products, the stays themselves are thinner, allowing for a smart installation. The thickness has been carefully adjusted through repeated prototyping and testing. Please be careful not to scratch the license plate when installing. Stays are made to accommodate the difference in spacing between US and JP license plate holes, but due to individual differences in US frames, it may be necessary to attach the stays at an angle or slightly modify the frame. Checking the frames in stock, there are variations in the hole diameters and the spacing between holes, with differences of about 5mm. I believe there are also compatibility issues with the vehicle body. The expansion and contraction of resin and iron, and slight misalignments of the mounting hardware. It's unlikely that all vehicles will be exactly the same without any millimeter deviations. Adding individual differences in the frames, the deviations can become significant. About one in a thousand people get angry because the dimensions don't fit! For those people, I think the only option is to have a custom-made one made to fit their vehicle and frame. Please refrain from purchasing if you cannot tolerate a deviation of a few millimeters. The corner radius varies depending on the individual product. US license plate frames have different mounting hole standards than Japanese standards, so stays are required for installation. ※ Number of sets required ※ 1 bolt = 1 set of stays ・Rear of regular car (with seal) Install with 1 set and double-sided tape. ・Rear of kei car (without seal) Install with 2 sets and double-sided tape. ・Front (for both regular and kei cars) Install with 2 sets and double-sided tape. For front and rear installation on a regular car, 3 sets are needed. For front and rear installation on a kei car, 4 sets are needed. Shipping is by Click Post only.