※For Manual Transmission Vehicles※ This is a small item storage tray for the new Jimny, located under the center console. It is installed by reusing the plastic rivets on both sides that secure the original tray. The surface has a textured finish to blend in with the interior. I made this because the original part was small and difficult to use. Made of 3D-printed ABS resin. ▽Caution▽ Heat-resistant ABS resin is used. Interior parts made of PLA resin are vulnerable to heat and will deform if used in a car during the summer. When purchasing 3D-printed parts, I strongly recommend ABS resin products.