Tamiya RC car, high upper bracket for TT-01 rear knuckle. Original part made by 3D printer. By attaching this bracket to the standard rear knuckle of the TT-01, you can install the pillow ball at a high position on the rear knuckle, enabling a high upper arm setup for the rear. Through meticulous design and fine 3D printing conditions, the play during installation can be reduced to almost zero with a single M3 screw. Please note that an M3 x 16mm or longer screw is required, so please prepare it separately. Before shipping, we will check the fit and play with the rear knuckle, and the screw holes will be tapped before shipment. Please note that the buyer should modify the rear upper arm to allow for camber adjustment. Also, if the rear knuckle has been changed to TT-01 specifications using other companies' rear lower arms, etc., it can be used on vehicles other than the TT-01. (The example in the photo shows it installed on a BT-01 and MB-01 using a prototype rear lower arm.) Thank you for your consideration. Type: Radio Control Car Manufacturer: Tamiya Type: RC Parts Radio Control Car: RC Limited Parts Material: PETG Color: Black #RadioControlCar #RadioControlDrift #Tamiya #tt01 #Drift #2WDDrift #AbikoParts