Handmade BlackMachine b6 clone. The body uses high-quality sen wood that has been naturally dried for over 20 years, and the neck is Itaya maple. The fingerboard is very good Indian rosewood, dried for over 10 years and as hard as ebony. The pickups, pegs, and bridge have been used for about 10 years, so there are scratches and dullness. The pickups are Jackson J-80 for the front and Lundgren M6 for the rear, and the pegs and bridge are Hipshot. The electrical system uses Sonic cables, CTS pots, and a Nue Device Nero for the tone. The frets are Jescar stainless jumbo frets. The truss rod uses a Tatsuta Titanium Parts 2-way titanium rod. The nut is buffalo horn, scalloped shallowly. Side dots are Luminlay. Body thickness is 35mm, the neck is U-shaped, 22mm at the 1st fret and about 24mm at the end, and the fingerboard thickness is 6mm. The fingerboard radius is a compound radius of 254mm to 356mm, and is not as flat as the original, but has a familiar radius. The jack is an endpin type. A case better than a semi-hard case will be an upcharge. Also, if you have pickups available in Japan, I will exchange them for free with an upcharge for the amount. Please comment if you would like to do so. #ibanez #esp #otakuguitar