Tantalizer Version ② (1 piece) ※ For followers only. If you wish to purchase with CELL or RSX brasier, add 1000 yen (or +600 yen for either one). Since it's just placed during disassembly and repair, I highly recommend it. Please refer to the product page for details on the PS3 brasier. ※ Purchase 3 or more of this product and receive the above brasier (RSX, CELL set) for free. ■ Product Description This is a repair part that replaces the two Proadrizers installed in the PS3 initial models (CECHA / CECHB / CECHH / CECHL, etc.) with a single board. In the conventional method, it was necessary to solder 8 capacitors one by one to replace the two Proadrizers, which was a difficult task for beginners, requiring the board to be shaved and the placement adjusted. With this Tantalizer Ver. ②, you can remove the Proadrizers (location is the red frame in the photo), place the board, and complete the replacement by soldering a few points. The board is equipped with 6 conductive polymer aluminum electrolytic capacitors of the 7343 size in parallel. ※ NEC/TOKIN Proadrizers capacity: approx. 1200uf per piece Capacity of this product (photo 3): approx. 2800uf ≒ equivalent to 2 pieces ESR is approx. 12mΩ ■ Main Features • Significantly reduces repair time • Beautiful finish • Easy to handle even for beginners • Even when replacing all Proadrizers, Conventional 32 capacitors → ver. ② only 4 boards are needed ■ Summary This product is a board designed to make the conventional "repair method of replacing capacitors in parallel" easier and more reliable. Please use it for YLOD repair and prevention of the PS3 initial models.