Have you ever found a trackball case with a three-point support system using ceramic balls difficult to use because the ball doesn't move smoothly or the start of the slide is sticky? A trackball case that uses bearings instead of ceramic balls will make the ball slide more lightly and significantly improve the operability. ■ Product Overview ・This is a 34mm trackball case designed by kepeo, which can be used for the Keyball series. ・It has a three-point support system with 2 bearings and 1 ceramic ball. ・The ceramic ball (black) and bearings will be sent to you already installed. ■ Included Items ・Keyball 34mm trackball case ・Screws (black) M1.7 6mm x 2 for connecting to the Keyball body ■ Points ・Made with a 3D printer. ・Made of PLA. ・Uses a 0.2mm fine nozzle. ・This listing is for black, but it can also be made in white or light gray if you wish. ・You can choose from white or black ceramic balls. ・You can choose from silver or black M1.7 6mm screws to attach to the Keyball body. ※If you would like to change the body color other than black, or the color of the ceramic ball or M1.7 screws, please feel free to contact us. ・We have tested the operation with the trackball installed. ・The trackball will not come off even if you turn it upside down. ・Supports tenting. ■ Notes ・Since it is made with a 3D printer, there may be layer lines and some roughness. Please understand this beforehand. ・The Keyball body, trackball, and keycaps shown in the example photos are not included. ・When installed on the Keyball, clearance can be secured between the trackball and the keycaps directly above it (photo 8), but when installed on the roBa, clearance may not be secured depending on the shape of the keycaps (photo 9: bearing interferes with the keycap, photo 10: bearing barely does not interfere with the keycap). ・We cannot accept returns for reasons related to the buyer's usage environment, such as interference with keycaps. Please understand this beforehand. #keyball #keyball39 #keyball44 #keyball61 #trackball case #bearing