This is a cover for the "PE Cross Double-Sided Tape," a commonly used double-sided tape in Mini 4WD. When using the tape, removing the protective film on the sides that comes with it from the start can cause dust to stick. By using this cover, you can store the double-sided tape in a clean condition for a long time. 【Contents】 Male mold x 2 (thickness 5mm, 10mm) Female mold x 1 (thickness 5mm) Spacer x 2 (thickness 5mm, 10mm) 10mm ring x 2 (thickness 2.5mm) Double-sided tape cutting board (bonus) The male mold and spacer can be connected on both sides. Depending on the combination, it can be used with tapes of various thicknesses. * For 10mm, 15mm, and 20mm widths, the tape fits perfectly when new. 25mm width can be attached, but it will stick out. If the 10mm width tape is reduced and becomes difficult to remove, attach two 2.5mm rings to the 15mm width cover and use it. The width will increase, making it easier to remove. The bonus tape cutting board can fold the edges, preventing the release paper and tape from separating when peeling.