EVH 5150III 2x12 Cabinet Ivory Works without issue. When I purchased it used, the emblems on the front center and lower right were removed, and the marks were blackened out. The rear plate is missing. According to the EVH website, the dimensions are "Width x Height x Depth 762 x 419.1 (excluding casters) x 356 mm, weight 27.22 kg." The size is almost identical, and the weight measured on a scale was 23.7 kg. The speakers are 12-inch Celestion Vintage 30s, loaded with two. Regarding the "3904 A" stamp on the side of the speaker: This is the official part number for the Celestion Vintage 30. • A = Variation symbol • VINTAGE 30 = Model name • 16Ω = Impedance • 50 10MV = Manufacturing lot code (manufactured in the 50th week of 2010) It is likely that this is a lot that had V30s installed from the time of shipment (EVH mixed G12H and V30 depending on the time and model), or the previous owner replaced the G12H with V30s. Visually confirmed the wiring, and it was connected in parallel, so the overall impedance is 8Ω. Operation has been confirmed when connected to a Marshall JCM2000, Hughes & Kettner Tube Meister 36, and Orange Dual Terror. The "NOT USE" jack on the back is an old model specification, and "NOT USE" is written on those that are not connected in the circuit. At the time, the same panel was used for the 4x12 cabinet, and it is a factory specification that leaves "terminals that are not used in that model" without being blocked, although "parts and circuit boards are shared." Therefore, as shown in the photo, it is not actually connected to the circuit, and it is a "dummy jack" where no signal passes even if a cable is inserted. The sound is, as expected from the Vintage 30, with a powerful mid-low range. The casters will be removed for packing. Will ship on weekends. ⭐︎If you pick it up directly, the shipping cost will be discounted!