※ This product is only the tilt stand. ※ Anonymous delivery Made with a 3D printer. This is a tilt stand for the trackball mouse logicool ERGO M575. (Also compatible with ERGO M575SP and M575S) The tilt angle is set to 25°. Using the tilt stand allows you to fix your wrist at a more natural angle. This enables operation with a relaxed arm posture, reducing the strain on your wrist. The color and texture are similar, without compromising the design of the trackball mouse itself. Five non-slip pads are attached to the back of the stand for stable use. You can operate the power switch while the stand is attached. It is fixed in two places: the ball hole and the cover groove. The USB receiver and battery cover can be stored inside the stand. Color: Black Material: (Body) PLA, (Non-slip) High-performance urethane foam 《Notes》 ・The trackball mouse itself is not included. ・Please refrain from using in high-temperature environments. (Heat resistance: approx. 60°C) ・3D printed products may have fine horizontal and vertical stripes, and stringing. ・Color may transfer from the non-slip pads to surfaces such as plywood flooring and vinyl flooring. ・Do not use the product for purposes other than its intended use. ・Do not engage in actions that may cause damage or rough handling. ・Do not use damaged or deformed products as they are. ・We inspect the product before shipping, but please contact us if there are any defects. We will respond as much as possible. ≪Installation Instructions≫ 1. Store the USB receiver in the stand. 2. Store the battery cover. 3. Hook the fixing claws onto the cover groove of the mouse body, and then insert the fixing protrusions into the ball hole.