※ This product is only the tilt stand. ※ Anonymous delivery. Made with a 3D printer. This is a tilt stand for the trackball mouse ProtoArc EM04. The tilt angle is set to 25°. Five non-slip pads are attached to the back of the stand, allowing for stable use. You can operate the power switch and mode switch button while the stand is attached. It is fixed in three places: the ball hole, the screw hole, and the cover groove. The USB receiver and cover can be stored inside the stand. Color: Black Material: (Body) PLA, (Non-slip) High-performance urethane foam Installation Instructions 1. Store the USB receiver in the stand. 2. Store the cover. 3. Align the tilt stand with the ball hole and screw hole of the trackball mouse body. Slowly push the tabs of the tilt stand until they click into place. 《Notes》 ・The trackball mouse body is not included. ・Please refrain from using in high-temperature environments. (Heat resistance: approx. 60°C) ・This is a 3D printed product, and there may be fine horizontal and vertical stripes, and stringing. ・Color may transfer from the non-slip pads to the contact surface, such as plywood flooring or vinyl flooring. ・Do not use for purposes other than the intended use of the product. ・Do not engage in actions that may cause damage or rough handling. ・Do not use damaged or deformed products as they are. ・We inspect the product before shipping, but please contact us if there are any defects. We will respond as much as possible.