~Handmade~ Polymer Clay Cutter *Ethnic Ember 40mm x 34mm* Color: Random This polymer clay cutter is made using PLA filament. Ethnic/BOHO style design with embossed patterns.*˖⋆ You can use the cut-out parts by threading a jump ring through them. 0.4mm edge for a clean cut, smooth processing after cutting and baking.*˖⋆ Rounded base that is gentle on fingers.*˖⋆ Size: Approximately Design part 40mm x 34mm Height 15mm Color: Random · · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · ·· · • • • ✤ • • • · · PLA filament is a material developed based on plant-derived PLA resin - mainly made from natural materials such as corn, potatoes, and tapioca, it is a plant-derived biodegradable bioplastic. This product uses high-purity, high-strength PLA/PLA+ filament.*˖⋆ ☆3D printing builds up by layering melted filament - We create with settings that minimize layer lines as much as possible, but please understand that there may be some areas where there are shifts, burrs, layer lines, and stringing. ☆When using, especially cutters with fine designs, apply cornstarch to the cutter when cutting, or remove the clay by pressing and removing it in small increments, rather than all at once, to prevent sticking and make it easier to remove. ☆Due to the nature of the product, clay may enter the layers. Please wipe it off using a soft brush or cloth without applying force. ☆Although it is a strong and tough material, excessive force, especially from a horizontal direction to the layers, may lead to damage, so please be careful. ☆PLA filament is generally sensitive to heat and softens even at low temperatures of around 60°C, so please be careful about the temperature when washing - Dishwashers cannot be used. #akikaClayCutter #polymerclay