Thank you for viewing! This is a rear single-axis anchor template. Currently supported chassis are: VZ, MS, S2, AR It is made based on the VZ chassis, and modifications are required for other chassis (S2 requires no modification). S2 chassis: See photo 13 MS chassis: See photo 14 AR chassis: See photo 15 Photo 2 shows an example of cutting. Photos 3 and 4 show examples of installation. What is for sale is everything in the first photo. For reference on the range of motion, please see photo 10. A motor hold-down jig is also included. This is attached on top of the original motor hold-down. It is tightened after raising it with a 3mm spacer, small washer, and spring washer. See photo 11 It is thought that it can be made easily by cutting according to the basic template and keeping a few points in mind. The following is a substitute for the instruction manual! Point 1 Be sure to attach a 1.5mm spacer to the recess of the anchor body in photo 5. Point 2 Attach a 1.5mm scrap material as shown in photo 6. Any scrap material is fine. Point 3 Cut the four pieces from the MS chassis multi-brake set in photo 7. The length is up to you. Angle the part that interferes with the anchor. If this is not done well, the return will be poor. Point 4 The protruding part that fixes the chassis stay in photo 8 can be used without modification. That's why there is a recess in the anchor body. Adjust the attitude control with the angle of the multi-brake set in Point 2. Point 5 Photo 9 shows the cuts needed for attachment to the chassis, but I've included this for reference as the height and differences are a matter of preference. The demo car in the photo has been stepped up. Feel free to do as you like. The plates used are as follows. Carbon multi-wide rear stay (including 3 motor hold-downs) Carbon rear brake stay (1) HG 13/19mm roller carbon multi-reinforcement plate set (1) 13mm rollers are assumed. The width is approximately 104.6mm. There is a slight buffer. Since it is made by an individual, there may be slight differences. It is compatible with the 19mm anchor sold separately, so you can change it by simply replacing the unit. See photo 12 If you have any questions, please feel free to ask.