Replacement parts for the Thinkpad Trackpoint Keyboard Ⅱ feet (tilt stand) if they are damaged. I designed and manufactured these myself using a 3D printer, and I am selling them. 1 pair: 700 yen 2 pairs: 1000 yen ← Recommended 3 pairs: 1300 yen Please understand the following before purchasing: 1) Regarding damage and wear While design improvements over four years have been implemented to prevent breakage, the material is plastic, so it will wear and break like the original. 2) Finish Due to the nature of 3D printing, the surface will have patterns as shown in the photos. Please understand that the appearance may vary, so please do not be concerned about the finish. 3) Compatibility with the keyboard Since I make these to fit my own keyboard, there is a possibility that they may not fit depending on the manufacturer's production period, etc. 4) Please replace both left and right feet at the same time The height is not matched to the original. 5) Discount There are no plans for discounts. 6) Notes on installation ・The most common cause of damage is improper installation. The incorrect installation shown in the photo will break immediately, so please be careful. ・If you force it in when installing, the shaft may break, so please install it carefully. ・Removal and reattachment are prone to damage and will shorten the lifespan. Before delivery, I will check the finish with a magnifying glass and test the installation on my own keyboard before sending it.