Thank you for viewing! I am making pickups under the series name "BCM rewind." This is a listing for an Alnico 3 rod humbucker, neck position. Finished using an automatic winder. Instead of a bar magnet, it's a "humbucker that's like two single coils side-by-side," using rod magnets found in single-coil pickups. In humbucker mode, it sounds more like a thick single-coil, and in coil-tapped mode, it has a single-coil tone. Alnico 3 provides a vivid tone with touch nuances. The resistance is high, but it tends to be higher because I'm winding more turns with a thinner coil than commonly used coils. Here's a sample: https://youtu.be/Fk6yaiNJqjY?si=e7dzoy8ZW-phB0H_ Alnico 3 Rod Humbucker Neck Position Only Magnets: Alnico 3 rod magnets Neck: Approximately 20kΩ Lead Wires: Mogami 4-conductor + ground, vinyl wire Lead Wire Length: ・Neck: 30cm Wax potted with beeswax Includes screws and springs ○ Also sold separately. If sold out, I can make and sell them if you give me some time. ※ Pickup resistance values may vary depending on temperature; please understand that there may be some slight errors. I will use recycled packaging materials for shipping. Since the parts are imported, there may be some minor scratches. Please purchase only if you understand this. I am also selling on other sites, so please forgive me if it sells out. ※ Please refrain from price negotiations. Discounts are available for bulk purchases, so please inquire. #guitar #pickup #remake #humbucker