It's been run several times, so there are scratches and dirt. Please check the condition in the photos. Since this is a handmade product, there may be some looseness or scratches and dirt from the manufacturing process. [Specs] Front Bumper: 2-axis AT Slidan Rear Bumper: 1-axis Anchor Tires: 23.5mm Black Low Friction Motor: Mach Dash 35700 rpm [Front Gimmick] ・It's a 2-axis self-made AT Slidan. ・The thrust angle can be adjusted by inserting washers etc. between the stay that attaches the rollers and the bumper. [Rear Gimmick] ・Using a straight plate, the rollers are placed at the back. ・The brake stay has a built-in skid roller. [Other] ・All bearings have been degreased and coated with special oil. ・The body has been painted with plastic paint over a flat clear coat. Therefore, the strength may be slightly lower compared to polycarbonate paint. Also, some areas that have cracked have been reinforced. ・The body can be attached and detached by sliding the plates on the left and right sides of the body. ・The gear cover is reinforced with carbon and made to be hard. Please be careful as it takes a little skill to remove it. ・The batteries are fixed to the chassis, so a battery cover is not necessary. ・It is made with a focus on design, so some areas have lower strength. ・Some parts were made before the regulation revisions, so please check the regulations when participating in store races. Photos 11 and 12 are measurements with a 20° bank checker. ※Third-party carbon is used. All parts other than carbon are genuine parts. Mini 4WD Avante Mk.II