Handmade item made with a 3D printer. Smelt fishing bait box Size: Approximately 90mm long x 150mm wide x 54mm high Mesh size: 1.5mm x 1.5mm The magnet-free system remains, but the mesh is now integrated instead of separate, the mesh depth is 22mm, and the lip on the top of the mesh has been enlarged. Remove the plate, shake to remove sawdust, then insert the plate to prevent the maggots from slipping through to the sawdust side. A slip-through prevention plate has been installed, so the mesh size has been increased to 1.5mm x 1.5mm to make it easier to remove sawdust. Magnets and non-slip silicone are attached to the bottom of the box. The magnets are low-profile, providing a secure grip during normal use. The magnets are designed to be compatible with a table that will be made in the future. Also, if your table is the type that magnets stick to, it will be securely fixed and easy to use. Since it is made with a 3D printer, there may be lines, burrs, unevenness, and minor scratches due to filament breaks, so please understand. m(_ _)m PLA plus material is used, which has a higher heat resistance than usual, but warping may occur at temperatures above 60 degrees Celsius, so please be careful of heat such as in the summer sun. Since it is a handmade item, it is unused, but I will consider it as having no noticeable scratches or stains. I check before shipping, but if there are any scratches or malfunctions, I will exchange it. Please contact me before rating. Nowadays, two electric smelt reels are the mainstream, and it's fun to catch a lot of fish. Let's enjoy stress-free fishing with magnet-free! The color of the hinges will be silver or gold.