This is a stand for 1/4 scale dolls. The base has a light blue cat-paw design. The fourth photo shows the set contents. The base is 11cm wide. The stand is adjustable as shown in the photo. It can be adjusted from 16 to 27 cm. The base is 1.5cm thick, so it will be longer if the pose doesn't have the feet on the stand. It has been confirmed that it can also be used for Azone AZO2, so it may also be usable for 50cm scale dolls, depending on the length of the inseam. Furthermore, when tested with Dollfie Dream DDdy, it could be used barefoot in a pose where the legs are slightly spread, straddling the base. (In the case of DDdy, the seat and thighs interfere, so the legs will be slightly spread.) The acrylic plate of the base will be delivered with a protective sheet attached, so please peel it off as needed. Some items may have had the protective sheet reapplied for inspection, or the bag may have been opened. Please understand. The rod that inserts into the base is quite tight, but it will fit if you twist it while inserting. *It is not the type that is inserted all the way in, so there is no need to force it in deeply. If it still won't fit, you can sand the insertion part of the stand rod little by little with sandpaper to make it easier to insert. Of course, it can also be used for figures other than dolls. If there are any remaining in stock, please contact us if you need multiple items. #MDD #SD #imomo #AZO2 #Obitsu50 #Azone #azone #DD #DDdy #DDS #DDP #DollfieDream #doll #figure #stand