This is a listing for a white Switchbot mount kit for a Jimbo Denki JWIDE SLIM series switch plate, 1-gang, QWP-1. I created this DIY part because a friend asked me to make a mount for a Switchbot for their light switch. The switch cover dimensions are 120mm (height) x 70mm (width). It is made using PLA resin with a home 3D printer. The precision and quality are not comparable to industrial products. Please be aware of this. Photo 1: The product. It consists of a mount base and mount parts. Items shown in other photos are not included. Please note. Photo 2: The areas to be removed for installing this kit are circled in red. The blue circles indicate areas that need to be loosened (lifted) slightly to slide in the mount base. The loosening目安 is 2mm. The "口" shaped part of the components in Photo 1 needs to be slid under the bottom of the switch cover component (below the metal plate component). After sliding it in, tighten the red and blue circled areas as appropriate to secure the mount base. Photo 3: Mount base installation complete. Photo 4: JIMBO switch components and switch cover installation complete. Photo 5: This is what it looks like with the Switchbot installed. Please remove the double-sided tape that comes with the Switchbot before use. Photo 6: In some cases, the Switchbot may shift slightly from the mount parts depending on the on/off behavior. This can be resolved by placing double-sided tape in the red square area, so please prepare and apply it as needed. After installation, some position adjustments specific to the Switchbot were necessary, but it seems to be able to stably control the seesaw-type switch by pushing and pulling. * In addition to white, color variations such as black, gray, beige, yellow, blue, and red are available. Please feel free to contact me.